|
In many instances, manufacturers need in one-time-only carburizing custom-made workpieces, however usage of available shaft furnaces is not economically driven in this case. The small tool producing companies often run into such problems as purchasing, installation and operation of a large-sized shaft furnace is a very expensive investment for them. Our company delivers PKM - CGC furnaces to solve these tasks.
 | |  | | PKM CGC | | Mixing unit, compressor |
 | | Box | Design features:
- The heating chamber design is based on that of the PKM furnace.
- The carburizing process is carried out in a heat-resistant box equipped with gas outlet and gas exit.
- The built-in Oxican-Gamma catalyst (for catalytic gas carburizing method)
- Carburizing temperature does not exceed 920°С (CGC technology).
- Carburizing rate is up to 0.4 mm/hour depending on the type of steel.
- No defect structures (cementite network, troostite).
- The device for supplying and mixing air with propane is available.
- Propane-air mixture with a ratio within the range of 1/7...1/12 is supplied during the heating.
- Gaseous propane consumption does not exceed 20 liters per hour.
- The furnace comes with a minicompressor for pumping air to be mixed.
* including the loading table
|
| Наименование |
Working chamber
dimensions,
L-W-H, mm |
Overall dimensions,
L-W-H, mm (А-В-С)
|
Box dimensions,
L-W-H, mm (D-E-F) |
Т max, °С |
Furnace power,
kW |
Table dimensions,
L-W-H, mm |
|
PKM 3.6.2-CGC
|
600-300-200 |
2550*-1300-1600 |
450-200-150 |
1150 |
18 |
1210-570-840 |
|
PKM 4.8.4-CGC
|
800-400-400 |
3000*-1600-1950 |
600-300-300 |
1150 |
21 |
1300-570-1000 |
|
|
 |
|
PGK 12.6.6/13 |
|
|
|
 |
|
PKM 6.12.5/12,5 |
|
|
|
 |
|
CGC 8.20/9,5 |
|
|
